Back again!
I guess in honor of football season ending I will finally put up the FSU football field beer pong table I made.
This one wasn't too hard, just a lot of measuring for accuracy, tracing and free handing.
What you'll need:
Big piece of plywood
Paint of your choice
Brushes
Things to trace (I printed mine of the internet)
A cup (for circles)
Ruler
Sealant
Painting this kind of plywood was a little difficult just because it absorbs the paint more and it's harder to get the paint in the cracks. But I do think it makes it look more like a football field because it makes it look like grass.
I measured about 1-1/2 inches for the white trim and the end zone line was the same. I taped all these lines out with painter's tape. The circles I traced with a big cup.
Then I painted in the end zones and also measured out the yardages. Between the inside of the white lines was measured to about 6 1/2 inches between each 10 yards. Your board may be a different length so you'll have to adjust. I free handed the numbers for the yardages and the dash marks in between.
Then I printed the ACC logo off of google and traced it onto the field.
After that I free handed the FLA State and the SEMINOLES onto the end zones.
I also painted a garnet line in the middle of all of the letters to match the real field.
Basically, if you are doing a different football field, just google a picture of it and follow that.
My end zones don't look exactly the same as the real field but I was working with a lot less space. Ha
Then came for the center of the field.
There was no way I could free hand the seminole head so I just went with another FSU logo that I free handed.
And that's it!
It's fairly simple if you just follow a picture off of the internet.
Happy Crafting!
Always,
Mel =)
